This DTC Cabinet Door Soft Close Hinge with Plate can be used for new installs or as a replacement for any cabinet door hinge including FERRARI cabinet door hinges. 

Please read carefully.  The holes drilled in your door must be as such:

You will need 3 holes if you are using a hinge with dowels. The holes are: a 35mm and 2 at 8mm. The 8mm holes are 45mm apart and offset 9.5mm from center of the 35mm hole.  If your door does not have the 8mm holes you can remove the plastic dowels on this hinge and use wood screws to attach the hinge to the door. ( screws not supplied with hinge).  This is a very common drilling pattern but please measure as there are others. 

The Plate ( this is the part that attached to your cabinet ) is a dual purpose plate. This means it can be used on a framed cabinet or a frameless cabinet.  We are pretty sure you will need to attach the Plate using new holes other than what you have now. If you have a framed cabinet then the plates little tabs will go against the front edge of the frame and you can use wood screws to attach it to the edge of of your frame.  If you have a frameless cabinet then the tabs on the plate will rest against the outside edge of your cabinet box as this will set the correct distance and you can use the correct length of wood screw to attach the plate to the cabinet side wall.  Screws for this are not included. 

This hinge has an opening  of 105 degree.  It has a full over of 9/16" and is adjustable 1/8" left and right.  It needs a 35mm hole depth of at least 11mm.  It is a Clip On Hinge which means once installed the door can be removed by pushing the button on the end of the plate.  Side to side adjustments are possible via a cam screw on the hinge.  

This is as showing, one hinge and one plate.